QIDI Studio V1.9.5.51

QIDIStudio.logo

This is version 1.9.5.51, which has been improved and fixed based on user feedback and experience, and has added some new features.

New printer and filaments

• New printer

We have released a new printer X-Plus-4. You can add this printer in the configuration options. 1 9 5_1

• New filaments

At the same time, we have added various new filaments, set relevant parameters through our testing, and adapted to multiple printers. 1 9 5_2

Improvement

• Improve the quality of 100 overhang

This is a function transplanted from Bambulab Studio, thank you Bambulab Studio. a. Add speed transitions between the overhang and non-overhang areas to improve cooling effectiveness. 1 9 5_3

Adjusting the smooth coefficient can control the length of the speed transition zone to improve the print quality overhang areas. 1 9 5_4

b. Differentiate between bridge walls and 100% overhang non-bridging walls, and use different printing speeds to improve the print quality of 100% overhang non-bridging walls. 1 9 5_5

Bugfix

1.Fixed error in the calibration page display and missing some content in Linux. 2.Fixed the bug that the button on the device page does not select the identifier after the user enters the port number when entering the IP address. 3.Fixed slicing errors that occurred in the case of multiple filaments. 4.Fixed the bug of premature failure of pressure. 5.Fixed the bug of premature failure of pressure in the case of multiple filaments. 6.Fixed the bug where the output printing time was incorrect, causing the printer to be unable to read the printing time. 7.Fix some online device link errors.

8.Fixed the bug of incorrect use of the top pattern. 9.Fixed the bug where the Gcode import browsing, "print", "send" and other buttons could be clicked. 10.Fixed chamber temperature control error. 11.Fix the error of X-Max3 connection failure.

Misc

1.Logo change. 1 9 5_6

2.When selecting PETG filaments during pressure pre calibration, a prompt pops up. 1 9 5_7

3.Change the spacing between models in flow calibration to prevent expected collisions. 1 9 5_8

4.Remember the user's selection of the "Seal" button. After the software is reopened, the button will be initialized to the selected state. 1 9 5_9

5.Updated the translation of software content and corrected some incorrect translations. 6.Add wiki hyperlinks to some pages. 7.Optimize UI and connection methods. 8.Remove some unnecessary instructions from Gcode. 9.Optimize the partial logic of the device interface. 10.Update some UI colors.